Comanche 2WD L6-242 4.0L VIN S MFI (1992)
Inspect the pulley hub position on the pump shaft. The end of the pump shaft should be flush with the end of the pulley hub (+/-.25mm or 0.01") as
shown in Figure 2. If the hub is not flush, reposition it using the procedure in section 19, pages 10 and 11 making sure that the shaft is flush with the end
of the hub.
POLICY:
Reimbursable within the provisions of the warranty.
TIME ALLOWANCE:
Labor Operation No. 19-70-45-90 ......... 0.9 Hrs.
FAILURE CODE:
51 - Improperly Installed