Comanche 2WD L6-242 4.0L VIN S MFI (1992)
Fig. 37 Key release lever installation
Fig. 42 Installing key-release lever & return spring
Fig. 43 Installing wave washer
2.
Assemble console shift models as follows:
a.
Insert lock sector through hole in lock cylinder housing, installing it on lock sector shaft. Ensure lock sector turns freely.
b.
Install lock rack preload spring. Bowed side of spring must contact lock rack when rack is installed.
c.
Assemble lock bolt and lock rack.
d.
Install assembled lock bolt and lock rack in lock cylinder housing. Mate lock rack block tooth with lock sector block tooth.
e.
Install key-release lever return spring over threaded pivot post on lock cylinder housing.
f.
Insert key-release lever finger into lock rack slot and position hole in lever over threaded pivot post on lock cylinder housing. Ensure inner
end of spring contacts release lever.
g.
Raise key-release lever slightly and install end of lever spring between lever and boss on housing.
h.
Lubricate and position wave washer on threaded pivot post. Washer should be resting on release lever.
i.
Position shroud on lock cylinder housing. Torque attaching screws to 18 inch lbs. Ensure wave washer is not displaced while attaching
shroud.
j.
Insert short, hooked end of remote rod in lock rack.
k.
Install assembled lock cylinder housing and shroud on steering column jacket. Torque attaching screws to 60 inch lbs.
