Comanche 2WD L6-242 4.0L VIN S MFI (1992)
12. Position an open-end wrench on the "flat" area at the outer end of the threaded rod tool to prevent it from turning and tighten the nut (at the outer
end of the threaded rod tool) against the support guide tool to "seat" the replacement axle shaft seal in the axle shaft tube bore.
13. Loosen the threaded rod tool nut.
14. Insert a drift punch into the hole in the seal secondary installation tool. While retaining the punch to prevent the installation tool from turning,
unthread the threaded rod tool from the seal secondary installation tool.
15. Remove the seal secondary installation tool via the shift motor housing opening. Remove the remaining installation tools from the axle shaft tube.
