Comanche 2WD V6-173 2.8L VIN W 2-bbl (1986)
Engine Mount: Service and Repair
Fig. 1 Front engine mount replacement
FRONT MOUNT
1. Disconnect battery ground cable.
2. Remove through bolt retaining nut (1), Fig. 1. Do not remove through bolt at this time.
3. Remove engine mount upper retaining bolt (3), then raise and support vehicle.
4. Support engine with a suitable jack, then remove engine mount lower retaining nut (4) and through bolt (2). On six cylinder engines, it may be
necessary to remove the air pump and hose assembly to allow removal of through bolt.
5. Raise engine slightly and remove engine mount (5).
6. Reverse procedure to install. Torque all nuts and bolts to 32 ft. lbs.