Comanche 4WD L4-150 2.5L VIN E TBI (1989)
Fig. 16 Manual valve shaft seal installation
Fig. 17 Sector spacer sleeve
5.
Coat replacement shaft seals with petroleum jelly and seat them in case, Fig. 16. Install new spacer sleeve on sector, Fig. 17.
6.
Lubricate manual valve shaft and install it in case, then lubricate sector and sleeve and install them on shaft.
7.
Align hole in spacer sleeve with notch in sector, then install shift sector roll pin. Tap pin into sector and shaft and stake sleeve to sector and shaft
securely.
8.
Connect park rod to sector, Fig. 14, then install park rod bracket, Fig. 13, and torque bolts to specifications.
9.
Install valve body, oil screen, oil pan and neutral switch.