Comanche 4WD L4-150 2.5L VIN H TBI (1986)
Figure 2
B.
Install a new heating system vacuum hose:
1.
Remove and discard the heating system vacuum hose located between the intake manifold and the vacuum reservoir (Figure 2).
2.
Install the provided new hose.
C.
Install the Recall Completion Label (California vehicles only):
1.
With a ball point pen, print your dealer code (5 digits) on the supplied Recall Completion Label.
2.
Peel the label from its backing and apply it near the Vehicle Emission Control Information Label located on the bulkhead.
Completion Reporting and Reimbursement
Claims for vehicles which have been serviced must be submitted by DIAL dealers on the DIAL System. Non DIAL dealers may submit WROS. Claims
submitted will be used by Chrysler to record recall service completions and provide dealer payments.
Enter only one VIN per claim on a WRO. Fill in the labor operation number and time allowance and write on the WRO "Emissions Recall # 276T --
Catalytic Converter." Do not enter other service claims on the same WRO.
Use the following labor operation number and time allowance:
Labor Operation
Time
Number
Allowance
Remove and replace catalytic
11276282
0.7 Hours
converter and heater system vacuum hose and (for California registered vehicles only) apply recall completion label.
Add the cost of the parts package and applicable dealer allowance to your claim.
Parts Return and Vehicle Availability Information
Parts Return
Removed catalytic converters must be returned to the Warranty Material Return Center.
Note:
See Warranty Policy and Procedure Manual, Chapter 6, Subsection H for complete recall claim processing and material return instructions.
Vehicle Not Available
If a vehicle is not available for this service for a known reason, let us know by filling out the pre-addressed Vehicle Disposition Form portion of the
Owner Recall Notification Form or describe the reason on a postcard and mail to:
