Comanche 4WD L4-150 2.5L VIN H TBI (1986)
2.
Remove wire harness connector (B) from the injector.
3.
Remove injector retaining clip screws (C).
4.
Remove injector retainer (D).
5.
Using a pair of small pliers, grasp the center collar (E) of the injector and carefully remove injector (F) with a lifting-twisting motion. Discard
upper and lower O-rings
(G)
and (H). Note that backup ring (J) fits above upper O-ring (G).
6.
Lubricate the replacement upper (G) and lower (H) O-rings with Lithium base grease. Install the O-rings in the housing bore.
NOTE:
Make certain that lower O-ring (H) is seated down in its bore.
7.
Install Backup ring (J) over upper O-ring (G).
8.
Position replacement injector (F) in throttle body (K) and center the nozzle in the lower housing bore.
