Comanche 4WD L4-150 2.5L VIN H TBI (1986)
Band: Adjustments
Rear Band Adjustment
REAR BAND ADJUSTMENT
The rear band adjustment is an internal adjustment. The transmission oil pan must be removed to gain access to the band adjusting screw.
Perform the adjustment by proceeding in the following manner:
1. Raise the vehicle.
2. Remove the oil pan and drain the fluid.
3. Inspect the fluid and filter for heavy accumulation of friction material or metal particles which indicate worn or damaged parts. However a very
light accumulation of this material is normal.
Rear Band Adjustment
4. Adjust the band as follows:
^
tighten the adjusting screw with 5 Nm (41 in. lbs.) torque using Torque Wrench 5853-B and a 1/4 hex-head socket wrench
^
back off the adjusting screw seven turns
^
hold the adjusting screw in position and install the locknut; tighten the locknut with 47 Nm (35 ft. lbs.) torque
5. Install the oil pan and replacement pan gasket. Tighten the oil pan bolts with 17 Nm (150 in. lbs.) torque.
6. Lower the vehicle.
7. Fill the transmission with AMC/Jeep/Renault, or equivalent Dexron II Automatic Transmission Fluid. Refer to Fluid Level and Condition for the
refill procedure.
See: Service and Repair/Procedures
