Comanche 4WD L4-150 2.5L VIN H TBI (1986)
Valve Body Removal And Installation
5. Align and install the valve body. Install the attaching screws finger-tight only.
6. Install the neutral switch.
7. Move the manual valve (in the valve body) to the neutral position. Align the valve body as necessary to align the neutral finger of the manual lever
with the neutral switch plunger.
8. Tighten the valve body attaching screws alternately and evenly with 11 Nm (100 in. lbs.) torque.
9. Install the oil filter. Tighten the attaching screws with 4 Nm (35 in. lbs.) torque.
10. Install the manual and throttle valve control levers and tighten the clamp bolts. Check both shafts for binding after tightening the bolts.
11. Install the oil pan and the replacement gasket. Tighten the oil pan bolts with 17 Nm (150 in. lbs.) torque.
12. Lower the vehicle.
13. Fill the transmission with AMC/Jeep/Renault or equivalent Dexron II Automatic Transmission Fluid. Refer to Fluid Level and Condition for the
refill procedure.
See: Service and Repair/Procedures
14. Adjust the gearshift and throttle linkage.
