Comanche 4WD L4-150 2.5L VIN P MFI (1991)
9.
Install the distributor, cap and ignition wires.
NOTE: Install the distributor so that the rotor is aligned with the No. 1 cylinder spark plug terminal on the cap when the distributor housing is
fully seated on the cylinder block.
10.
Install the hydraulic valve tappets and the push rods.
11.
Install the rocker arms and bridge and pivot assemblies. Tighten each of the two capscrews for each bridge alternately, one turn at a time to avoid
damaging the bridge.
NOTE: Lubricate the hydraulic valve tappets and all valve actuating components with AMC Engine Oil Supplement (EOS), or equivalent, during
installation. The EOS must remain with the engine oil for at least 1,000 miles (1609 km) but need not be drained until the next scheduled oil
change.
12.
Install the cylinder head cover. Install the radiator, connect the hoses and fill the cooling system to the specified level.
13.
Check the ignition timing and adjust as necessary.
