Comanche 4WD L4-150 2.5L VIN P MFI (1991)
8. Position the threaded rod tool nut 51 mm or 2 inch away from the support guide tool.
9. With the support guide tool "seated" in the outer end of the axle shaft tube, strike the end of the threaded rod tool with a brass hammer to force the
axle shaft seal.
10. Remove the threaded rod tool (with the support guide tool and the seal removal tool) from the axle shaft tube.
11. Remove the seal removal tool from the end of the threaded rod tool.
NOTE: If applicable, (for convenience) do not install a replacement axle shaft inner seal until after the intermediate axle shaft bushing has been
replaced.
lnstallation MJ, XJ And YJ Vehicles
1. Ensure that the seal contact area in the axle shaft tube bore is clean.
2. Slide support guide tool and spacer sleeve tool over threaded rod tool.
3. Insert the threaded rod tool (with the support guide tool and the spacer sleeve tool) into the outer end and through the right-side axle shaft tube
until the end is visible in the shift motor housing opening. Ensure that the support guide tool is "seated" in the end of the axle shaft tube.
4. Apply a light film of oil to the inside lip of the replacement axle shaft seal.
