jeep Workshop Repair Guides

Jeep Workshop Service and Repair Manuals

Manifold Pressure/Vacuum Sensor > < Component Locations|Page 1586
Page 1
background image

Charge Temperature Sensor: Service and Repair

IAT And TPS Sensors

NOTE:

The MAT sensor is installed into the intake manifold plenum.

REMOVAL

1.

Disconnect the electrical connector from the air temperature sensor.

2.

Remove the sensor from the intake manifold.

INSTALLATION

1.

Install the air temperature sensor into the intake manifold. Torque the sensor to 28 Nm (20 ft.lbs.).

2.

Connect the electrical connector to the air temperature sensor.

Manifold Pressure/Vacuum Sensor > < Component Locations|Page 1586