Comanche 4WD L6-242 4.0L VIN S MFI (1992)
Neutral Safety Switch: Service and Repair
Park/Neutral (Inhibitor) Switch
NEUTRAL SWITCH REMOVAL
1.
Raise vehicle.
2.
Disconnect switch wire harness connector.
Park/Neutral Switch Removal
3.
Pry washer lock tabs upward and remove switch attaching nut and tabbed washer.
4.
Remove switch adjusting bolt.
5.
Slide switch off manual valve shaft.
NEUTRAL SWITCH INSTALLATION AND ADJUSTMENT
1.
Disconnect shift linkage rod from shift lever on left side of transmission.
2.
Rotate manual shift lever all the way rear-ward. Then rotate lever forward two detent positions to Neutral.
3.
Install switch on manual valve shaft and install switch adjusting bolt finger tight. Do not tighten bolt at this time.
4.
Install tabbed washer on manual valve shaft and install switch attaching nut. Tighten nut to 6.9 Nm (61 in. lbs.) torque but do not bend washer lock
tabs over nut at this time.
5.
Verify that transmission is in Neutral.
