Comanche 4WD L6-242 4.0L VIN S MFI (1992)
l.
Proceed to next step to complete assembly procedure.
3.
On all models, install lock cylinder in housing. Insert key into cylinder, rotating cylinder until key is aligned with keyway in housing. Push lock
cylinder inward, then install retaining screw, torquing to 40 inch lbs.
4.
Turn lock cylinder to On position, then install key warning buzzer switch.
Fig. 44 Ignition switch slider positions
5.
Install ignition switch as follows:
a.
Move ignition switch slider to Accessory position then back two clicks to the Off (unlocked) position. Remote rod hole in ignition switch
slider should now be centered.
b.
Insert remote rod in ignition switch slider hole, then install ignition switch on steering column jacket.
6.
Install lower bearing, adapter, retainer and spring clip at lower end of steering column.
7.
Install steering shaft through lower end of steering column, inserting it into upper bearing.
8.
Position turn signal switch and wire harness in lock cylinder housing.
9.
Install windshield wiper wire harness and switch.
10.
Align turn signal switch in housing, torque attaching screw to 35 inch lbs.
11.
Install dimmer switch actuator arm, torque attaching screws to 35 inch lbs.
12.
Install turn signal/wiper/dimmer switch/cruise control (if equipped) stalk by pushing it straight into column.
13. Position thrust washer, upper bearing preload spring and canceling cam on steering shaft.
14.
Place turn signal switch in neutral position, then install hazard warning switch knob.
Fig. 45 Installing lockplate snap ring
15.
Position lockplate on steering shaft and install new lockplate snap ring on sleeve of compressor tool. Install compressor tool on steering shaft.
16.
Compress lockplate, then position snap ring in steering shaft groove. Ensure snap ring is completely seated in groove before removing
compressor tool.
17.
Remove compressor tool No. J-23653-B or equivalent, then install lockplate cover.
18.
Install steering wheel. Torque retaining nut to 25 ft. lbs.
19.
Install steering column in vehicle, then connect battery ground cable.
