Comanche 4WD L6-242 4.0L VIN S MFI (1992)
Valve Body Solenoids
6.
Remove bolt attaching solenoids to valve body and remove solenoids. Do not allow any valve body components to fall out when solenoids are
removed.
7.
Clean oil filter and pan with solvent and dry with compressed air.
8.
Remove old sealer material from oil pan and transmission case.
SOLENOID INSTALLATION
1.
Position solenoids on valve body and install solenoid bolts. Tighten bolts to 10 Nm (7 ft. lbs.) torque.
2.
Connect feed wires to solenoids.
3.
Install new gaskets on oil screen and install screen. Tighten screen bolts to 10 Nm (7 ft. lbs.) torque.
4.
Apply bead of Three-Bond TB 1281 or equivalent sealer to oil pan sealing surface. Sealer bead should be at least 1.0 mm (.040 in.) wide.
5.
Install oil pan on transmission. Tighten pan bolts to 7.4 Nm (65 in. lbs.) torque.
6.
Install and tighten oil pan drain plug to 20 Nm (15 ft. lbs.) torque.
7.
Fill transmission with Mopar Mercon or Dexron II transmission fluid.
SOLENOID HARNESS ADAPTER SEAL REPLACEMENT
1.
Remove oil pan and oil screen. Refer to Solenoid Removal procedure.
Solenoid Wire Connectors
2.
Disconnect solenoid wire connectors.
Harness Adaptor Removal/Installation
