Commander 2WD V6-3.7L (2009)
Antenna Cable: Service and Repair
Instrument Panel Antenna Cable - Removal
REMOVAL
WARNING: Disable the airbag system before attempting any steering wheel, steering column, seat belt tensioner, side airbag or instrument
panel component diagnosis or service. Disconnect and isolate the negative battery (ground) cable. Wait two minutes for the airbag
system capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the airbag
system. Failure to follow these instructions may result in accidental airbag deployment and possible serious or fatal injury.
DOMESTIC
1. Disconnect and isolate the battery negative cable.
2. Remove radio See: Radio, Stereo, and Compact Disc/Radio/Stereo/Service and Repair/Removal and Replacement/Radio - Removal.
CAUTION: Pulling the antenna cable straight out of the radio without pulling on the locking antenna connector could damage the cable or
radio.
3. Disconnect the antenna cable by pulling the locking antenna connector (2) away from the radio (1).
4. Remove the glove box.
5. Remove instrument panel side panel.
6. Disconnect instrument panel cable (1) from antenna body and cable (2).
