Commander 2WD V6-3.7L (2009)
the left side of the vehicle.
2. With the display lens held flush against the face of the headliner, position the molded plastic retainer (3) over the display housing and flush against
the headliner substrate.
3. Slide the retainer toward the right side of the vehicle to lock the display into place.
4. Reconnect the wire harness connector (1) to the connector receptacle on the left end of the display housing.
5. Reinstall the trim onto both upper D-pillars. See: Body and Frame/Interior Moulding / Trim/Trim Panel/Service and Repair/Pillar Trim/D-Pillar
Trim/Installation.
6. Reinstall the trim onto the upper liftgate opening. See: Body and Frame/Doors, Hood and Trunk/Trunk / Liftgate/Trunk / Liftgate Interior Trim
Panel/Service and Repair/Liftgate Trim Panel - Installation.
7. Reconnect the battery negative cable.
