Commander 2WD V6-3.7L (2009)
WARNING: Disable the airbag system before attempting any steering wheel, steering column, seat belt tensioner, side airbag or instrument
panel component diagnosis or service. Disconnect and isolate the negative battery (ground) cable. Wait two minutes for the airbag
system capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the airbag
system. Failure to follow these instructions may result in accidental airbag deployment and possible serious or fatal injury.
1. Disconnect and isolate the battery negative cable.
2. Remove speaker grille from instrument panel.
3. Remove speaker from instrument panel.
4. Disconnect wire harness connector from speaker.
REAR DOOR
