Commander 2WD V6-3.7L (2009)
Rear Door Latch: Service and Repair
Rear Door Latch - Installation
INSTALLATION
1. If removed, install the actuator rods onto the rear door latch (3) and engage the retainers.
2. Position the rear door latch and actuator rods into the door as an assembly. Make sure the lock knob rod passes through the hole in the inner door
panel.
3. Install the three bolts (1) that secure the rear door latch to the door. Tighten the bolts to 10.5 Nm (95 in. lbs.).
4. Connect the door wire harness connector (2) to the rear door latch.
5. Install the interior handle actuator rod onto the rear door latch and engage the retainer.
6. Connect the actuator rod (1) to the rear exterior handle (2).