Commander 2WD V6-3.7L (2009)
4. Position the seat belt turning loop (4) onto the height adjuster (5) on the upper b-pillar. Be certain that the seat belt webbing between the retractor
and the turning loop is not twisted.
5. Install the screw (3) that secures the turning loop to the height adjuster. Tighten the screw to 39 Nm (29 ft. Lbs.).
6. Insert the upper tabs of the turning loop trim cover into the slots of the height adjuster on the upper b-pillar, then lower the bottom of the cover and
use hand pressure to press firmly and evenly on the cover until it snaps into place.
Lower
REMOVAL
1. Adjust the front seat to its most forward position for easiest access to the front seat belt lower anchor cover (1) and the B-pillar trim.
2. Grasp the upper edge of the lower anchor cover and pull upward to unsnap it from the front seat cushion outboard side shield.
3. Remove the screw (2) that secures the lower anchor to the outboard side of the front seat cushion frame and position the seat belt out of the way.
