Commander 2WD V6-3.7L (2009)
The rear blend door actuator (1) is a reversible, 12 volt direct current (DC), servo motor. The rear blend door actuator is located on the back of the rear
HVAC housing. The rear blend door actuator is interchangeable with the actuator for the mode-air door. Each actuator is contained within an identical
molded plastic housing with an integral wire connector receptacle (2). Three integral mounting tabs (4) allow the actuator to be secured to the rear
HVAC housing. Each actuator also has an identical output shaft with splines (3) that connects it to the rear air door. The rear blend door actuator does
require mechanical indexing to the rear blend-air door, as it is electronically calibrated by the A/C-heater control.
