Commander 2WD V6-3.7L (2009)
Traction Control Indicator Lamp: Description and Operation
Traction Control Indicator - Operation
OPERATION
The traction control indicator gives an indication to the vehicle operator when the Electronic Stability Program (ESP)/Brake Assist System
(BAS)/Traction Control System (TCS) has been activated. This indicator is controlled by the instrument cluster logic circuit based upon cluster
programming and electronic messages received by the cluster from the Controller Antilock Brake (CAB) over the Controller Area Network (CAN) data
bus.
The traction control indicator is completely controlled by the instrument cluster logic circuit, and that logic will only allow this indicator to operate when
the instrument cluster receives a battery current input on the fused ignition switch output (run-start) circuit. Therefore, the indicator will always be OFF
when the ignition switch is in any position except ON or START. The indicator only illuminates when it is provided a path to ground by the instrument
cluster circuitry. The instrument cluster will turn ON the traction control indicator for the following reasons:
-
Bulb Test - Each time the ignition switch is turned to the ON position the traction control indicator is illuminated for about four seconds as a bulb
test. The entire bulb test is a function of the CAB.
-
Traction Control Indicator Lamp-On Message - Each time the cluster receives an electronic traction control indicator lamp-ON message
from the CAB indicating that the ESP/BAS/TCS has been activated, the traction control indicator will be illuminated. The indicator can be flashed
ON and OFF, or illuminated solid, as dictated by the CAB message. The indicator remains illuminated solid or continues to flash until the cluster
receives a lamp-OFF message from the CAB, or until the ignition switch is turned to the OFF position, whichever occurs first.
-
Self Test - Each time the cluster is put through the self test, the traction control indicator will be turned ON, then OFF again during the bulb check
portion of the test to confirm the functionality of the LED and the cluster control circuitry.
The CAB continually monitors the traction control switch to determine the proper outputs to the components of the Antilock Brake System (ABS). The
CAB then sends the proper lamp-ON or lamp-OFF message to the instrument cluster, also known as the Cab Compartment Node (CCN).
For proper diagnosis of the traction control switch, the ESP/BAS/TCS, the CAB, the CCN, the CAN data bus or the electronic communication related to
traction control indicator operation a diagnostic scan tool is required. Refer to the appropriate diagnostic information.
