Commander 2WD V6-3.7L (2009)
CAUTION: Always use the correct bulb size and type for replacement. An incorrect bulb size or type may overheat and cause damage to the
lamp, the socket or the lamp wiring.
1. Align the base of the bulb (4) with the bulb holder within the liftgate lamp housing (3).
2. Push the bulb into the holder until the base is fully seated.
3. Align the lens (5) to the lamp housing.
4. Using hand pressure, press firmly and evenly on the lens until it snaps into place over the lamp housing.
5. Reinstall the lamp into the liftgate trim panel (1). See: .
6. Reconnect the battery negative cable.
