Commander 2WD V6-3.7L (2009)
3. Insert the large tab on the rear end of the lamp lens (1) into the rear of the lamp housing.
4. Using hand pressure, push the small tab at the upper front corner of the lens (2) rearward and inward towards the lamp housing until it snaps into
place.
5. Reconnect the battery negative cable.
Third Row
BULB - THIRD ROW
CAUTION: Always use the correct bulb size and type for replacement. An incorrect bulb size or type may overheat and cause damage to the
lamp, the socket or the lamp wiring.
1. Align the ends of the bulb (3) with the two bulb holders within the rear dome lamp housing (1).
2. Carefully press the bulb firmly and evenly into the bulb holders until it snaps into place.
3. Swing the notched end of the lens (4) up into position against the housing, then press upward on the lens firmly and evenly until it snaps into the
housing.
4. Reconnect the battery negative cable.
