Commander 2WD V6-3.7L (2009)
Marker Lamp Bulb: Service and Repair
Position Lamp Bulb - Installation
BULB - POSITION LAMP
CAUTION: Always use the correct bulb size and type for replacement. An incorrect bulb size or type may overheat and cause damage to the
lamp, the socket or the lamp wiring.
NOTE: The following procedure applies only to vehicles manufactured for export markets. Vehicles manufactured for North American
markets do not have a position lamp bulb, socket or wiring provided in the front lamp unit.
1. Align the base of the bulb with the position lamp bulb socket.
2. Push the bulb straight into the socket until the base is firmly seated.
3. Align the socket and bulb with the keyed opening on the bottom of the front lamp unit housing.
4. Insert the socket and bulb into the housing until the socket is firmly seated.
5. Rotate the socket clockwise about 30 degrees to lock it into place.
6. Reinstall the front lamp unit onto the front of the vehicle. See: Headlamp/Headlamp Bulb/Service and Repair/Front Lamp Unit Boot - Installation.
