Commander 2WD V6-3.7L (2009)
Turn Signal Bulb: Service and Repair
Side Repeater Lamp Bulb - Installation
BULB
CAUTION: Always use the correct bulb size and type for replacement. An incorrect bulb size or type may overheat and cause damage to the
lamp, the socket or the lamp wiring.
NOTE: Repeater lamps are used only on vehicles manufactured for certain markets where these lamps are required.
1. Align the base of the bulb (3) with the socket (1).
2. Push the bulb straight into the socket until the base is firmly seated.
3. Be certain that a rubber O-ring seal (2) is properly installed and in good condition around the base of the bulb socket.
4. Align the socket and bulb with the keyed opening on the back of the repeater lamp lens/housing (4).
5. Insert the socket and bulb into the housing until the socket is firmly seated.
6. Rotate the socket clockwise about 30 degrees to lock it into place.
7. Reinstall the repeater lamp into the fender mounting hole. . See: Service and Repair/Side Repeater Lamp - Installation
8. Reconnect the battery negative cable.
