Commander 2WD V6-3.7L (2009)
13. Evacuate the refrigerant system See: Heating and Air Conditioning/Service and Repair/Refrigerant System Evacuate.
14. Adjust the refrigerant oil level See: Heating and Air Conditioning/Service and Repair/Refrigerant Oil Level.
15. Charge the refrigerant system See: Heating and Air Conditioning/Service and Repair/Refrigerant System Charge.
Front
REMOVAL
WARNING: Refer to the applicable warnings and cautions for this system before performing the following operation See: Heating and Air
Conditioning/Service Precautions/Warning and See: Heating and Air Conditioning/Service Precautions/Caution . Failure to follow these
instructions may result in serious or fatal injury.
NOTE: LHD model with 5.7L engine shown. RHD model and other engines similar.
1. Disconnect and isolate the negative battery cable.
2. Recover the refrigerant from the refrigerant system See: Heating and Air Conditioning/Service and Repair/Refrigerant System Recovery.
3. Remove the air cleaner housing, air intake tube and the resonator .
4. Remove the nut (3) that secures the A/C suction line (2) and the A/C liquid line (10) to the A/C expansion valve (1).
5. Disconnect the A/C suction line from the A/C expansion valve and remove and discard the O-ring seal.
6. Remove the nut (1) that secures the A/C liquid line (2) to the A/C receiver/drier (3).
7. Disconnect the A/C liquid line from the A/C receiver/drier and remove and discard the dual plane seal.
