Commander 2WD V6-3.7L (2009)
8. Disengage the two liquid line retainer clips (4) from the right frame rail (3). If required remove the clips from the liquid line
9. Disconnect the A/C liquid line (1) from the A/C expansion valve (2) and remove and discard the O-ring seal.
10. Install plugs in, or tape over the opened liquid and suction line fittings and the receiver/drier and expansion valve ports.
11. Remove the A/C liquid line from the engine compartment.
Rear
REMOVAL
WARNING: Refer to the applicable warnings and cautions for this system before performing the following operation See: Heating and Air
Conditioning/Service Precautions/Warning and See: Heating and Air Conditioning/Service Precautions/Caution . Failure to follow these
instructions may result in serious or fatal injury.
NOTE: 4.7L engine shown. Other engines similar.
1. Disconnect and isolate the negative battery cable.
2. Recover the refrigerant from the refrigerant system See: Heating and Air Conditioning/Service and Repair/Refrigerant System Recovery.
3. Raise and support the vehicle.
4. Remove the nut (4) that secures the tapping block of the liquid line extension tube (6) to the underbody liquid line (5).
5. Disconnect the liquid line extension tube from the underbody liquid line and remove and discard the O-ring seal.
6. Lower the vehicle.
7. Disconnect the A/C liquid line (1) from the front A/C expansion valve (2) and the receiver/drier (3) and remove the A/C liquid line from the
engine compartment See: A/C Liquid Line - Removal.
8. Install plugs in, or tape over the opened refrigerant line fittings and expansion valve and receiver/drier ports.
Front
INSTALLATION
