Commander 2WD V6-3.7L (2009)
2. Remove the screw (3) that secures the second row center seat belt lower anchor to the outboard side of the right center seat support bracket.
3. Using a trim stick or another suitable wide flat-bladed tool, carefully pry the seat belt escutcheon (2) upward far enough to disengage the barrel
clips that secure it to the top of the second row center seat back (1).
4. Slide the seat belt webbing (3) through the slot (4) in the escutcheon to remove the escutcheon from the belt.
5. Remove the trim from the back and the top of the second row center seat back frame.
6. Pull the foam seat back cushion (2) away from the front upper right corner of the center seat back frame far enough to access and remove the two
screws (1) that secure the retractor shield (3) to the seat back frame.
7. Remove the retractor shield from the seat back frame.
