Commander 2WD V6-3.7L (2009)
Seat Heater Switch: Service and Repair
Heated Seat Switch - Removal
Front
REMOVAL
1. Disconnect and isolate the battery negative cable.
2. Remove the instrument panel center bezel.
3. Remove the lower instrument panel switch pod fasteners.
4. Remove the lower instrument panel switch pod from the vehicle.
Second Row
REMOVAL
1. Disconnect and isolate the battery negative cable.
2. Using a trim stick (special tool # C-4755) or equivalent, gently pry the upper edge of the floor console rear trim panel (1) to release the retaining
clips at all of the locations around the floor console rear trim panel (3).
3. Lift up and rearward to release the panel lower tabs (2) from the floor console.