Commander 2WD V6-3.7L (2009)
Auxiliary Power Outlet: Service and Repair
Power Outlet - Installation
12 V Power Outlet
INSTALLATION
1. Connect the instrument panel wire harness connector to the cigar lighter or power outlet receptacle base connector receptacle.
2. Install the cigar lighter or power outlet mount into the instrument panel.
3. Align the splines on the outside of the cigar lighter or power outlet receptacle base connector receptacle with the grooves on the inside of the
mount.
4. Press firmly on the cigar lighter or power outlet receptacle base until the retaining bosses of the mount are fully engaged in their receptacles.
5. Install the cigar lighter knob and element into the cigar lighter receptacle base, or the protective cap into the power outlet receptacle base.
6. Connect the battery negative cable.
115 V Power Outlet
INSTALLATION
1. Install the 2nd row heated seat switch assembly into the floor console rear trim panel. Push the switch firmly into the trim panel until the retaining
tabs are fully seated.
2. If equipped, connect the 2nd row heated seat switches (1), 115 Volt power outlet (3) and the auxiliary audio jacks (2) electrical connectors to the
floor console rear trim panel.
3. Align the trim panel (3) to the console and insert the bottom tabs into the mounting slots.
4. Tilt the upper edge of the trim panel (1) forward and apply hand pressure to seat all retaining clips.
5. Connect the battery negative cable.
