Commander 2WD V6-3.7L (2009)
6. Install the steering knuckle (3) to the upper ball joint (2) and tighten the nut (4) to 95 Nm (70 ft. lbs.)See: Front Steering Knuckle/Service and
Repair/Front Steering Knuckle - Installation.
7. Install the tire and wheel assembly.
8. Lower the vehicle.
9. Perform wheel alignment See: Alignment/Service and Repair.
Left Side
LEFT SIDE
1. Raise and support the vehicle.
2. Support the rear axle.
3. Lower the fuel tank in order to gain access to the bolt See: Powertrain Management/Fuel Delivery and Air Induction/Fuel Tank/Service and
Repair/Removal and Replacement/Fuel Tank - Removal.
4. Remove the upper suspension arm nut (2) and bolt (3) from the axle bracket.
