Commander 2WD V6-3.7L (2009)
Axle Bearing: Service and Repair
Installation
INSTALLATION
NOTE: If a bearing flange stud is loose or has backed out tighten stud to 27 Nm (20 ft. lbs.).
1. Install axle flange bolts into axle flange.
2. Tap axle shaft through axle bearing into wheel flange.
3. Install axle shaft (1) into axle tube and backing plate with new O-ring on axle.
4. Slip O-ring (2) through backing plate, then push axle through backing plate until bearing (1) is exposed.
5. Install O-ring (2) axle bearing.
