Commander 2WD V6-3.7L (2009)
rear wiper arm onto the liftgate with the tab (3) of the wiper arm support (4) positioned on the park ramp (2) as shown and the tapered mounting
hole on the pivot end of the arm positioned over the rear wiper motor output shaft.
2. With the rear wiper arm properly indexed, push the tapered mounting hole on the pivot end of the wiper arm down over the output shaft.
3. Install and tighten the nut that secures the rear wiper arm to the rear wiper motor output shaft. Tighten the nut to 10 Nm (86 in. lbs.).
4. Move the rear wiper arm support to its parked position within the cradle of the park ramp.
5. Wet the liftgate glass and operate the rear wiper. Turn the rear wiper switch to the Off position, then check for correct wiper arm support position
on the park ramp and readjust as required.
6. Position the plastic cap over the pivot end of the rear wiper arm and press firmly and evenly on the cap until it snaps into place.
