Commander 2WD V6-3.7L VIN K (2006)
13. Carefully cut the foam seal (1) along the parting line (2) of the two halves of the air distribution housing (3). If the seal is deformed or damaged, it
must be replaced.
14. Remove the 4 metal clips (4) that secure the two halves of the air distribution housing together.
15. Remove the eight screws (5) that secure the two halves of the air distribution housing together.
16. Carefully separate the left half of the air distribution housing (1) from the right half of the air distribution housing (2).
17. Remove the center partition (3) from the distribution housing.
NOTE: If the seal on any air door is deformed or damaged, the air door must be replaced.
