Commander 2WD V8-4.7L (2008)
INSTALLATION - ELECTRONIC VEHICLE INFORMATION CENTER CONTROL SWITCH
1. Position the steering wheel switch onto the switch bezel aligning the switch tabs (1) with the bezel retainers (2).
2. Press the switch into the bezel until the switch is held in place by all four retainers.
3. Position the switch and bezel assembly (3) over the steering wheel and connect the switch electrical connector.
4. Align the switch bezel tab (1) with the slot in the steering wheel and press the switch and bezel assembly (3) into the steering wheel until it is
secured in place.
5. Install the driver airbag, See: Restraint Systems/Air Bag Systems/Air Bag/Service and Repair/Driver Airbag - Installation.
6. Do not reconnect the battery negative cable at this time. The Supplemental Restraint System (SRS) verification test procedure should be performed
following service of any SRS component. See: Powertrain Management/Computers and Control Systems/Testing and Inspection/Diagnostic
Trouble Code Tests and Associated Procedures/Verification Tests.
7. Connect the battery negative cable.