Commander 2WD V8-4.7L (2008)
Radio Receiver: Service and Repair
Removal
REMOVAL
WARNING: Disable the airbag system before attempting any steering wheel, steering column, seat belt tensioner, side airbag, or instrument
panel component diagnosis or service. Disconnect and isolate the battery negative (ground) cable, then wait two minutes for the airbag system
capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the airbag system. Failure to take the
proper precautions could result in accidental airbag deployment and possible personal injury.
1. Disconnect and isolate the battery negative cable.
2. Fold and tumble the right outboard second row seat assembly forward.
3. Remove the carpeted cover panel from over the cavity on the right outboard end of the intermediate step assembly.
4. Remove the mounting fasteners.
5. Disconnect the antenna and electrical harness connectors.
6. Remove the module.