Commander 2WD V8-4.7L (2008)
Hood Sensor/Switch (For Alarm): Service and Repair
Hood Ajar Switch Bracket
Removal
BRACKET
1. Remove the hood ajar switch from the mounting bracket (3). See: Hood Ajar Switch - Removal.
2. Remove the two screws (4) that secure the hood ajar switch bracket to the rivet nuts (2) in the left fender inner shield (1).
3. Remove the hood ajar switch bracket from the left fender inner shield.
Installation
BRACKET
1. Check to be certain that the two rivet nuts (2) that secure the hood ajar switch bracket screws to the left fender inner shield (1) are properly
installed and in good condition.
2. Position the hood ajar switch bracket (3) onto the left fender inner shield.
3. Install and tighten the two screws (4) that secure the hood ajar switch bracket to the left fender inner shield. Tighten the screws to 4 Nm (35 in.
lbs.).
4. Install a new hood ajar switch into the mounting bracket. See: Hood Ajar Switch - Installation.