Commander 2WD V8-4.7L (2008)
Power Trunk / Liftgate Control Module: Service and Repair
Removal
REMOVAL
1. Disconnect and isolate the battery negative cable.
2. Remove the left quarter trim panel from the vehicle, . See: Interior Moulding / Trim/Trim Panel/Service and Repair/Quarter Panel Trim/Quarter
Trim Panel - Removal
3. Disconnect the wire harness connectors (3) from the power liftgate control module (1).
4. Remove the power liftgate control module (1) from the left rear wheel well (2).
5. Remove the module (1) from the vehicle.
