Commander 2WD V8-4.7L (2008)
1. Position the load floor in the vehicle.
2. Install the two nuts that secure the load floor to the floor panel.
3. Install the liftgate scuff plate, See: Scuff Plate/Service and Repair/Liftgate Sill Scuff Plate - Installation.
Removal
REMOVAL
1. Using a small flat-bladed tool, carefully open the two fastener covers located in the A-pillar trim panel.
2. Remove the two bolts that secure the A-pillar trim panel to the A-pillar and remove the trim panel.
Installation
INSTALLATION
