Commander 2WD V8-4.7L (2008)
1. Position the locating tabs of the A-pillar trim panel into the slots located in the top of the instrument panel.
2. Install the A-pillar trim panel onto the A-pillar and install the two bolts. Tighten the bolts to 6 Nm (55 in. lbs.).
3. Close the two fastener covers located in the A-pillar trim panel.
Removal
REMOVAL
1. Adjust the front seat to its most forward position for easiest access to the front seat belt lower anchor cover (1) and the B-pillar trim.
2. Grasp the upper edge of the lower anchor cover and pull upward to unsnap it from the front seat cushion outboard side shield.
3. Remove the screw (2) that secures the lower anchor to the outboard side of the front seat cushion frame and position the seat belt out of the way.
4. Remove the front door sill scuff plate, See: Scuff Plate/Service and Repair/Sill Cover-Interior/Removal.
