Commander 2WD V8-4.7L (2008)
3. Install the upper B-pillar trim panel, See: Pillar Trim/B-Pillar Trim.
4. Position the seat belt lower anchor to the mounting hole on the outboard side of the front seat cushion frame. Be certain that the seat belt webbing
between the turning loop and the lower anchor is not twisted.
5. Install the screw (2) that secures the lower anchor to the seat. Tighten the screw to 39 Nm (29 ft. lbs.).
6. Reinstall the lower anchor cover (1) onto the front seat cushion outboard side shield.
7. Position the seat belt aside and close the access door on the lower B-pillar trim panel.
8. Install the rear door sill scuff plate, See: Scuff Plate/Service and Repair/Sill Cover-Interior/Installation.
9. Install the front door sill scuff plate, See: Scuff Plate/Service and Repair/Sill Cover-Interior/Installation.
Removal
