Commander 2WD V8-4.7L (2008)
Brake Shoe: Service and Repair
Brake Shoes - Installation
INSTALLATION
1. Install the park brake shoes (1) onto the actuator lever (2).
2. Install shoes on support plate with hold down clips and pins (4). Be sure shoes are properly engaged in the park brake actuator lever (2).
3. Install the return spring (3).
4. Lubricate and install adjuster screw assembly (5). Be sure notched ends of screw assembly are properly seated on shoes and that star wheel is
aligned with access hole in the support plate.
5. Install shoe to shoe adjuster spring (6). Needle nose pliers can be used to connect spring to each shoe.
6. Install the axle shaft (1) to the rear differential See: Transmission and Drivetrain/Drive Axles, Bearings and Joints/Axle Shaft Assembly/Axle
Shaft/Service and Repair/Rear Axle - C213R/Installation.