Commander 2WD V8-4.7L (2008)
3. Start reservoir in o-rings then press the reservoir straight down to seat the reservoir into the cylinder o-rings.
CAUTION: Do not rock the reservoir during installation.
4. Verify retaining tabs are seated.
5. Install the wire connector to the brake fluid level sensor (2).
6. Remove brake pedal prop rod.
7. Fill master cylinder.
Master Cylinder - Removal
REMOVAL
1. Siphon the master cylinder.
2. Remove the primary brake line (6) at the master cylinder.
3. Remove the secondary brake line (6) at the master cylinder.
4. Disconnect the brake fluid level switch (7) from the master cylinder.
5. Remove the 2 master cylinder mounting nuts (8).
6. Remove the master cylinder.
Master Cylinder - Installation
INSTALLATION
NOTE: Bleed new master cylinder on bench before installation.
