Commander 2WD V8-4.7L (2008)
Parking Brake Pedal: Service and Repair
Removal
Non-Adjustable Pedal
NON-ADJUSTABLE PEDAL
1. Disconnect the negative battery cable.
2. Remove retainer clip (1) that holds booster to pedal pin (3).
3. Remove the power brake booster See: Power Brake Assist/Vacuum Brake Booster/Service and Repair/Power Brake Booster - Removal.
4. Lock the steering wheel into place.
5. Remove the 2 intermediate shaft bearing nuts (1).
6. Remove the lower steering shaft pinch bolt.
7. Remove the lower steering shaft off the column.
8. Loosen the brake pedal sled upper nuts
9. Remove the brake pedal assembly from the vehicle.
Adjustable Pedals
ADJUSTABLE PEDALS
NOTE: If possible put the pedals in the full forward position.
1. Disconnect the negative battery cable.
2. Remove the power brake booster See: Power Brake Assist/Vacuum Brake Booster/Service and Repair/Power Brake Booster - Removal.