Commander 2WD V8-4.7L (2008)
2. Connect the radiator upper and lower hoses and hose clamps to radiator.
CAUTION: The tangs on the hose clamps must be positioned straight down.
3. Install coolant reserve/overflow tank hose at radiator.
4. Connect both transmission cooler lines at the radiator.
5. Install both radiator mounting bolts.
6. Install air inlet duct at grille.
7. Attach electric connector for hydraulic fan control solenoid.
8. Install the grille See: Body and Frame/Grille/Service and Repair/Grille - Installation.
9. Connect the two high pressure lines to the hydraulic fan drive. Tighten 1/2 in. pressure line fitting to 49 Nm (36 ft. lbs.). and the 3/8 in. pressure
line fitting to 29 Nm (21 ft. lbs.).
10. Connect the low pressure hose to the hydraulic fan drive. Position the spring clamp.
11. Connect the power steering filter hoses to the filter. Install new hose clamps.
12. Rotate the fan blades (by hand) and check for interference at fan shroud.
13. Refill cooling system See: Service and Repair.
14. Refill the power steering reservoir and bleed air from system See: Steering and Suspension/Steering/Power Steering/Power Steering
Bleeding/Service and Repair.
15. Connect battery cable at battery.
16. Start and warm engine. Check for leaks.
