Commander 2WD V8-4.7L (2008)
1. Remove the instrument panel and place it on a workbench See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service
and Repair/Instrument Panel - Removal.
2. Remove the instrument panel top cover (1) from the instrument panel.
3. Remove the screws that secure the left and right instrument panel and demister duct assemblies (2 and 4) to the instrument panel top cover.
4. Disconnect the instrument panel and demister duct assemblies from the main distribution duct (3) and the panel end outlets (5) and remove the
duct assemblies.
5. Remove the screws that secure the center instrument panel ducts (6) to the instrument panel top cover.
6. Disconnect the center instrument panel ducts from the main distribution duct and remove the center ducts.
Front Instrument Panel Ducts - Installation
INSTALLATION
1. Position the left and right instrument panel and demister duct assemblies (2 and 4) to the instrument panel top cover (1).
2. Connect the instrument panel and demister duct assemblies to the panel end outlets (5) and the main distribution duct (3). Make sure that the duct
assemblies are correctly installed over the outlet seals.
3. Install the screws that secure the instrument panel and demister duct assemblies to the instrument panel top cover. Tighten the screws to 2 Nm (17
in. lbs.).
4. Position the center instrument panel ducts (6) to the instrument panel top cover.
5. Connect the center instrument panel ducts to the main distribution duct.
6. Install the screws that secure the center instrument panel ducts to the instrument panel top cover. Tighten the screws to 2 Nm (17 in. lbs.).
7. Install the instrument panel top cover onto the instrument panel.
8. Install the instrument panel See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service and Repair/Instrument Panel -
Installation.
Rear Distribution Ducts - Removal
REMOVAL
UPPER DISTRIBUTION DUCT
NOTE: Right side upper distribution duct shown in illustration. Left side duct similar.
