jeep Workshop Repair Guides

Jeep Workshop Service and Repair Manuals

Front Heater Core - Removal|Page 8278 > < Front Heater Core - Description|Page 8275
Page 1
background image

Heater Core: Service and Repair
Front Heater Core - Removal

REMOVAL

WARNING: Refer to the applicable warnings and cautions for this system before performing the following operation See: Service
Precautions/Warning and See: Service Precautions/Caution. Failure to follow the warnings and cautions could result in possible personal
injury or death.

WARNING: Disable the airbag system before attempting any steering wheel, steering column, or instrument panel component diagnosis or
service. Disconnect and isolate the negative battery (ground) cable, then wait two minutes for the airbag system capacitor to discharge before
performing further diagnosis or service. This is the only sure way to disable the airbag system. Failure to take the proper precautions could
result in accidental airbag deployment and possible personal injury or death.

NOTE: Take the proper precautions to protect the front face of the instrument panel from cosmetic damage while performing this procedure.

1. Disconnect and isolate the negative battery cable.
2. Drain the engine cooling system See: Engine, Cooling and Exhaust/Cooling System/Service and Repair.
3. If required, disconnect the heater hoses from the heater core tubes in the engine compartment.
4. Remove the instrument panel See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service and Repair/Instrument Panel -

Removal.

5. Remove the five screws (1) that secure the heater core and tube cover (2) to the HVAC housing (3).
6. Remove the heater core and tube cover from the HVAC housing.

7. If equipped with dual zone heating-A/C, remove the blend door actuator (1) from the passenger side of the HVAC air distribution housing (2) See:

Air Door/Air Door Actuator / Motor/Service and Repair/Blend Door Actuator - Removal.

8. Remove the screw (3) that secure the heater core tubes (4) and retaining bracket (5) to the HVAC housing (6).

NOTE: Take proper precautions to protect the carpeting from engine coolant. Have absorbent toweling readily available to clean up any
spills.

Front Heater Core - Removal|Page 8278 > < Front Heater Core - Description|Page 8275