Commander 2WD V8-4.7L (2008)
HOUSING-HVAC ASSEMBLY
NOTE: The HVAC housing must be removed from the vehicle and disassembled for service of the air inlet housing, air distribution housing and
the A/C evaporator.
1. Position the HVAC housing assembly (2) into the passenger compartment side of the dash panel (3). Make sure that the condensate drain tube
protrudes through the opening in the floor panel.
2. Loosely install the nut (1) that secures the HVAC housing to the passenger compartment side of the dash panel.
3. Install the two bolts (1) that secure the HVAC housing assembly (2) to the engine compartment side of the dash panel (3). Tighten the bolts to 7
Nm (62 in. lbs.).
4. Connect the heater hoses to the heater core tubes.
5. Connect the A/C suction line and A/C liquid line to the A/C evaporator See: Hose/Line HVAC/Service and Repair/Removal and Replacement/A/C
Line - Installation.
