Commander 2WD V8-4.7L (2008)
8. Remove the screws (1) that secure the rear floor/console door actuator (2) to the right side of the air distribution housing (3) and remove the
actuator.
9. If equipped with dual zone heating-A/C, remove the screws (6) that secure the blend door actuator (7) to the right side of the air distribution
housing and remove the actuator.
10. If equipped with dual zone heating-A/C, remove the screws (4) that secure the blend door actuator mounting bracket (5) to the right side of the air
distribution housing and remove the mounting bracket.
11. On LHD models equipped with dual zone heating-A/C, remove the blend door stop (1) from the right side of the air distribution housing (2).
12. On LHD models carefully pull the heater core (3) out of the right side of the air distribution housing.
13. Carefully cut the foam seal (1) along the parting line (2) of the two halves of the air distribution housing (3). If the seal is deformed or damaged, it
must be replaced.
14. Remove the 4 metal clips (4) that secure the two halves of the air distribution housing together.
15. Remove the eight screws (5) that secure the two halves of the air distribution housing together.
